Automatic winding machine operation before pay attention to?

A, automatic winding machine and its auxiliary equipment inspection and maintenance

1. Horizontal winding machine inspection and maintenance

1) often check the lubrication condition of the rotating parts, to ensure good lubrication.

2) check each part of bolt fastening, found loose to tight in time, after especially the tailstock bottom bolt must be solid and reliable

3) the machine turns, don't allow below the winding operation.

4) work, always check whether bending of the faceplate and the tailstock and fracture phenomenon, found that the problem timely repair.

5) machine turns, does not allow for reversing, speed shift operation.

2. Vertical winding machine inspection and maintenance

1) check the faceplate and winding mode have docking bolt fastening, otherwise must be retightened.

2) winding unsafe factors such as mechanical and electrical source to see if there is any breakage, if any should be ruled out.

3) check whether telescopic cover expansion is good, and adjust the size of the opening and closing to about 150 ram disc or winding winding diameter distance, in order to ensure safe operation.

4) check the winding machine for hanging around with or hamper the operation of equipment or other objects, otherwise should again decorate line tray tooling the position of the object, etc.

After checked the above-mentioned content, just can begin winding machine winding.

Second, the winding compaction machine and assembly inspection and maintenance

1) lifting system work is normal, if there is jammed, tilt, stall failure or unsafe factors, should ask professional maintenance and eliminate unsafe factors.

2) electric part of power supply and cover to see if there is any breakage or unsafe factors, if any should be ruled out.

3) whether the winding center and compaction mechanism is, or is.

4) under compaction machine operators, starting pressure machine, the following are not allowed to stand.

5) hydraulic pressure machine must check pressure gauge whether in use within the time limit, the reading is correct, hydraulic station work is normal, the hydraulic oil is enough, or rear can operation should be ruled out.